Silk paint flows across the fibre. Gutta gives that flow an edge. Draw a line, the line forms a barrier in the silk, and the colour spreads up to it and stops.
The technique is quick to learn. The key is a continuous line with every shape fully closed, and most of this guide is about drawing one.
What is in the set
The Gutta Resist Set is three 30ml bottles, each with a fine tip applicator. Metallic Gold, Metallic Silver and Clear. All three are water-based and quick drying.
Gold and Silver give every shape a metallic edge, a little like the leading in stained glass. Clear keeps the silk under the line uncoloured, so each shape is framed by a fine line of the silk itself.
Choose Gold or Silver where the outline is part of the design, and Clear where the colour should take the lead.
Set up the silk
- Wash and dryWash and dry the silk if it is new.
- StretchStretch it on a silk frame so it is taut and lifted off the table. A taut surface makes a steady line far easier to draw.
- Plan the drawingSketch the design on paper first. Fine silk is thin enough to see through, so you can hold the drawing underneath and follow it.
- TestShake the bottle well. Draw a few lines and closed shapes on a spare piece of the same silk to get used to the flow.
Draw the line
Every shape needs a continuous line with no gaps. A closed outline holds the colour inside it.
- Hold it like a penRest the tip lightly on the silk. Squeeze gently and evenly as you move, so the line stays the same width.
- Close every shapeDraw each shape as one continuous outline. Where two lines meet, overlap them slightly.
- Check against the lightHold the frame up to the light and follow every line with your eye. Close any gap with a touch more gutta.
- Check the backTurn the frame over. The line should show on the reverse as well. Where it sits only on the top, go over it again.
- Let it dryLet the gutta dry completely before any paint goes on.

Paint inside the lines
Load a soft brush with silk paint and touch it to the middle of a shape. Let the colour flow out to the line on its own. A lightly loaded brush gives the cleanest edge.
Colours still blend inside a shape. Put Rose Pink in the heart of a petal and a thinner wash of it towards the edge. Run Green into Yellow on a leaf while both are wet.
Fix the colour
When the paint is completely dry, fix your silk paints as their instructions say. For FABCO Silk Paint that means an iron on the cotton setting, on the reverse side, for about 5 minutes. Wait at least 24 hours, then wash gently by hand in cool water with a mild detergent.
The full method for painting, blending and heat setting is in how to paint a silk scarf.
Looking after the bottles
Keep the bottles out of direct sunlight and do not let them freeze. Close the caps tightly between uses, and use the gutta within 12 months of opening.
Questions
What is gutta used for in silk painting?
Gutta is a resist. You draw outlines with it on the silk and let them dry. When you paint inside a shape, the colour spreads up to the line and stops. That gives clean edges and keeps each colour in its own shape.
How do you stop silk paint bleeding through a gutta line?
Draw each outline as one continuous line with no gaps, check that it shows on the back of the silk, and let it dry completely before painting. Hold the silk up to the light to check the line. Close any gap with more gutta and let that dry before you paint again.
What is the difference between clear gutta and gold or silver gutta?
Gold and silver gutta draw a metallic outline around each shape. Clear gutta keeps the silk under the line uncoloured, so the outline is the colour of the silk itself. Paint, fix and wash a spare piece first to see each finished line on your silk.
FABCO Colours Library, No. 13. Published 12 October 2026.
